HOW TO WORK WITH MODULES FROM MERCEDES-BENZ TRUCKS ON BENCH AS IF IN THE TRUCK? EASY, USING THE ZN181 SET CAN GATEWAY SET!
With the latest hardware set we launched; it is super easy to work with modules from Mercedes-Benz trucks on bench.
The ZN181 allows you to program Infrared keys for these trucks, and also cobined with the designated cables for MCM and TCU modules (CB603 and CB604), you can set these modules to virgin state and personalize them effortlessly!
NO more working in the truck for hours!
NO more need for using other tools!
Done in just a few minutes!
Can be done in the comfort of your workshop!
All is done via the ABRITES Diagnostics for Mercedes-Benz trucks offline menu in a few clicks! The MN031 DAS Manager for Mercedes-Benz trucks and buses is the required software license to use all the ABRITES functionalities for these vehicles.
ZN181 CAN Gateway Set Contents
The ZN181 CAN Gateway Set contains the CAN gateway device, cable CB601 and CB602 cable. The CB601 cable is used to connect the CAN gateway to AVDI, the CB602 cable is used to connect the EZS/EIS, or the electronic ignition switch to the CAN gateway in order to be able to program keys.
Key Programming Procedure
The procedure is very simple, it only takes a few minutes! In case you also need a key to program, do not worry, we’ve got you! Get the TA69 Infrared key for Mercedes-Benz trucks, and get the job done! See how it works:
Setting Modules to Virgin State
Setting MCM (control module) and TCU (transmission control module) from Mercedes-Benz trucks is made very convenient with the CB603 cable for connecting to MCM modules, and the CB604 cable for connection to TCU modules. The reset procedure takes less than a minute and is a mandatory first step for reusing second-hand modules. See how it’s done:
Personalization of MCM and TCU Modules to the EZS Completely on Bench
The whole personalization of the MCM and TCU modules on bench using the ZN181 CAN Gateway Set requires the EZS module to be present. In this process, you personalize these units to the electronic ignition switch. First, you need to reset the modules, which is done almost instantly with the click of the “Virgin” button in the software. Keep in mind that the reset step is a must, especially when you are working with second-hand modules! Once you are done with the setting to virgin state step, you can go on to personalizing them, again intuitively, by clicking the “Personalize” button. After that, the activation of the modules happens when they are installed in the truck. Watch the whole procedure in the video below:
This solution is perfect for specialists who regularly have to work with Mercedes-Benz trucks. It is a fast and reliable way to complete all the necessary tasks for module replacement and key learning for these vehicles.
Also, a 24V/4A adapter is needed to provide power to the modules.
All the required software and hardware for these procedures is as follows:
Software:
- MN031 DAS Manager for Mercedes-Benz Trucks and Buses (including Setra)
- AMS Annual Maintenance Subscription
Hardware:
